Gmsp index
Gipsy Major 1 & 10 Spare Parts List
GIPSY MAJOR 1 and 10 ENGINES
Amendment No. 25, February 1990|
|
Page
|
|
|
7
|
| |
|
Accessory drives, revolution indicator drive |
8
|
|
|
Accessory drives, magneto drive |
10
|
|
|
Airscoop and baffle |
13
|
|
|
Camshaft and tappets |
17
|
|
|
Carburettor |
19
|
|
|
Carburettor air-intake and flame trap housing |
25
|
|
|
Carburettor flooder |
23
|
|
|
Cockpit data plate |
108
|
|
|
Connecting rods and pistons |
29
|
|
|
Controls |
31
|
|
|
Crankcase |
35
|
|
|
Crankshaft |
41
|
|
|
Cylinder and cylinder head |
43
|
|
|
Fuel pumps |
49
|
|
|
Ignition, plain |
55
|
|
|
Ignition, screened |
59
|
|
|
Impulse starter |
65
|
|
|
Induction pipe |
67
|
|
|
Magnetos |
71
|
|
|
Oil pressure filter |
79
|
|
|
Oil pressure gauge connections |
81
|
|
|
Oil pump and housing |
83
|
|
|
Oil suction and scavenge filters |
87
|
|
|
Oversize, undersize and special repair parts |
131
|
|
|
Pipes, fuel and oil |
89
|
|
|
Pipes, oil |
91
|
|
|
Propeller boss (Major 1 and Major 10 Mk. 1) |
93
|
|
|
Settling tank |
99
|
|
|
Timing gear cover |
101
|
|
|
Transport spares |
105
|
|
|
Optional equipment, not fitted to basic engine |
107
|
|
|
Accessory drive shaft for vacuum pump |
111
|
|
|
Accessory drive shaft for vacuum pump and generator |
110
|
|
|
Air-intake extension |
109
|
|
|
Bearer arms |
109
|
|
|
Carburettor flooder, finger ring. |
107
|
|
|
Crankshaft, tapered (Major 1 and Major 10 Mk. 1) |
119
|
|
|
Crankshaft, tapered (conversion) (Mod. 2495) |
120
|
|
|
Exhaust manifold. |
109
|
|
|
Generator, and additional parts required |
112
|
|
|
Generator and vacuum pump, additional parts required |
113
|
|
|
Hand turning gear |
115
|
|
|
Primer pipes |
107
|
|
|
Propeller boss (metal propellers). |
119
|
|
|
Propeller boss (wooden propellers). |
121
|
|
|
Revolution indicator drives |
116
|
|
|
Starter |
108
|
|
|
Starter adapter |
108
|
|
|
Thermocouple, cylinder head. |
108
|
|
|
Vacuum pump, and additional parts required |
117
|
|
|
Variation to standard, for alternative installation in Auster J5/L (Mod. 2290) Major 10 Mk. 2-1. |
125
|
|
|
Numerical index of part numbers |
199
|
|
|
|
This spare parts list covers the Gipsy Major Series 1, and the Gipsy Major 10 Mark 1 and Mark 2. Throuhgout the list the part numbers and quantities required (No. o’ff) are arranged in three columns headed to indicate the engine to which they may be fitted. The 'description' column is divided into sub-columns (numbered 1, 2, 3, 4, 5 and 6) and the parts listed in any one subcolumn are those components of the preceding assembly or sub-assembly which can be supplied separately from that complete assembly. Parts marked * are not normally supplied separately as spares.
A REGISTRATION AND CHANGE OF ADDRESS CARD is provided at the back of this Spare Parts List. Recipients are requested to complete and post the REGISTRATION CARD immediately they receive the List if they wish to be included in the circulation of subsequent amendments. Unless a registration card is received no amendments can be forwarded. So that distribution records can be kept up to date please use the CHANGE OF ADDRESS CARD when applicable or in the event of a transfer in the ownership of this List.
Every effort has been made to provide an amendment system which, while being as nearly foolproof as possible, shall cause the holder of the List as little clerical work as practical and enable anyone to see at a glance the amendment state of this List.
All amendments will be accompanied by a new TITLE PAGE. This will carry a statement:—
Month 195-. This copy includes amendments Nos. and
On the BACK of the new title page will be the “ instructions ” and a note of the preceding amendments. Unless an amendment is small (i.e., changing a few figures or words) a new leaf/s (page or pages) will be issued. Each new leaf will carry a note at its bottom right-hand corner:—
Revised (or issued) by amendment No. -, month 195-.
Where a new leaf is not issued the “ instructions ” will conclude with a reminder that the holder of the List should make a note:—
“ Revised by amendment No. month 195-.”
at the foot of each page altered.
IMPORTANT.—Before commencing to insert amendments into this Sparc Parts List, make a check to ensure that the preceding amendment has been incorporated. It is essential that all amendments are incorporated in strict numerical sequence. Failure to do this can cause considerable confusion and renders the statement on the title page “ This copy includes amendment No............” untrue, since each amendment is compiled on the assumption that it is to be incorporated into a Spare Parts List containing all the preceding amendments.
